Engineering, 25.11.2021 05:30 ptrlvn01

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film is exposed to stagnant 100% O2 gas maintained at 1.5 atm. Oxygen gas is sparingly soluble in the silicone polymer film, with the solubility relationship given by Ca = S* Pa with S = 3:16 g mol O2/m3 silicone atm O2 at 298 K. Initially, there is 0.39 g mol O2/m3 uniformly dissolved in the film. The diffusion coefficient of O2 in silicone is 1 × 10-11 m2/s at 298 K. a. At a very short time of 10 s, O2 does not penetrate very far into the silicone polymer film. Under this physical situation, what is the flux of O2 into the surface of the silicone polymer film at this time? b. At a much longer time, the dissolved O2 concentration in the silicone polymer film at the polymer/inert interface is now 3.0 g mol/m3. How long will it take to achieve this concentration?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film i...

Questions