subject
Engineering, 11.11.2021 14:00 gumbyseth1969p45qjl

Lamont at LiveGreen Construction Materials is concerned about how the marketing department at LiveGreen represents some of the company’s products. He feels that marketers make sustainability claims for all of LiveGreen’s products that don’t always apply. For example, an adhesive compound might be low emission and thereby green by that standard, but not produced in the most sustainable way, which is what the marketing copy for the compound claims. What’s the best plan for Lamont to reform marketing practices at his company? Only identify products as green if everything from their production to their intended use to their disposal can be considered green.

Only indicate green qualities for a product if it meets at least three of the green activities identified in the DOL O*NET taxonomic standards.

Identify products as green if they possess any plausibly green attributes but make no specific claims for any product.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
Lamont at LiveGreen Construction Materials is concerned about how the marketing department at LiveGr...
Questions
question
Mathematics, 15.11.2019 06:31
question
Mathematics, 15.11.2019 06:31
question
Mathematics, 15.11.2019 06:31
question
Geography, 15.11.2019 06:31
Questions on the website: 13722363