subject
Engineering, 06.11.2021 02:40 kelseeygee

* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature reading on a thermometer if they put the thermometer inside a mitten (see diagram A above). Both thermometers started at room temperature. Annika’s group obtained two thermometers and a mitten. They put one thermometer inside the mitten and the other thermometer on the table next to the mitten. An hour later they compared the readings on the two thermometers. The temperature inside the room remained the same during their experiment. The thermometer inside the mitten will have a lower temperature reading than the thermometer on the table because the mitten will conduct the cold air outside the thermometer. Both thermometers will have the same temperature reading because the mitten doesn’t generate additional heat. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will trap the warm air inside the mitten. The thermometer inside the mitten will have a higher temperature reading than the thermometer on the table because the mitten will insulate the thermometer.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
* 4. Annika’s class is investigating energy. They wonder what would happen to the temperature readin...
Questions
question
Mathematics, 02.10.2020 15:01
question
Mathematics, 02.10.2020 15:01
question
Mathematics, 02.10.2020 15:01
Questions on the website: 13722363