Engineering, 23.10.2021 05:10 scarletmartinez

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one ofinsulation (as shown in the figure). Heating is accomplished by an electric heater. Inside the oven there is a fanto homogenize the temperature ( T = X °C, h = 50 W/m2°C). Lab environmental condition are (T = 25 °C, h =(X/20) W/m2°C).(a) Calculate thickness of insulation (k = 0.015 W/m°C) to reduce heat transfer up to (100/2.5)%.(b) Calculate the temperature on the outer surface of the oven.(c) Calculate heat transfer from brick-1.(d) If it is assumed that the same heat transfer from all six sides, calculate the cost of electricity for threehour. (use 30 Rs/kw-h))

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one o...

Questions