Engineering, 11.10.2021 06:00 yanelyportillo7

A sphere 30mm in diameter initially at 800K is quenched in large bath having a constant temperature of 320K with a convection heat transfer coefficient of 75W/m^2. K. The thermo-physical properties of the sphere material are rho = 400kg/m^3, c = 1600 J/kg. K, and k = 1.7W/m K. a) Sketch the temperature gradient in the sphere over time with temperature (y-axis) and radius (x-axis) showing several lines to represent the initial time, an intermediate time, and the temperature at after a long time has elapsed. Note the boundary conditions you assumed in the center of the sphere and the edge of the sphere and show them on your sketch b) Calculate the Biot number and determine the best solution path using a characteristic length of gamma _o. c) Calculate the time required for the surface of the sphere to reach 415K [seconds]. d) At the time found, determine the heat flux [W/m^2] from the surface of the sphere.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

A sphere 30mm in diameter initially at 800K is quenched in large bath having a constant temperature...

Questions