Engineering, 18.09.2021 03:10 loki285
In a short essay, discuss the question, "How are you an innovator?"
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
In a short essay, discuss the question, "How are you an innovator?"...
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00
Mathematics, 10.02.2021 05:00