Engineering, 07.09.2021 19:40 christhegreat1

problem 2 (25 pts) design a low pass butterworth filter to remove high frequency noise from a signal with a nyquist frequency of 1000 hz meeting the following design requirements: 1. the dynamic error to be less than 0.01 at 500 hz or lower frequencies and 2. the attenuation at 4.5 khz or higher frequencies to be at least 25 db the filter cutolt frequency is to be 1500 hz. take the source and load impedances as 50 n. part a) 10 pts find the order of the butterworth filter required lo mcet the above design criteria. part b) 10 pts find the values of the capacitors and inductors required to construct the filter and draw a circuit dingram of the filter. part c) 5 pts at what lowest frequency this signal must be sampled so that signal aliasing is avoided

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Arigid tank contains 10 kg of air at 137 kpa (abs) and 21°c. more air is added to the tank until the pressure and temperature rise to 242 kpa (abs) and 32°c, respectively. determine the amount of air added to the tank. [r-0.287 kj/kg k]

Answers: 3

Answer

You know the right answer?

problem 2 (25 pts) design a low pass butterworth filter to remove high frequency noise from a signal...

Questions