Engineering, 01.09.2021 01:40 crystal070903
Building codes usually specify that deflections (Bending downward at the center) in a floor joist for residential buildings should not exceed 1/360 of the span under normal loads. What fraction of an inch would this equal for a span of 10'-0"? Show your calculations below.
Answers: 1
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
Building codes usually specify that deflections (Bending downward at the center) in a floor joist fo...
Mathematics, 26.10.2020 15:30
Mathematics, 26.10.2020 15:30
History, 26.10.2020 15:30
Mathematics, 26.10.2020 15:30
Biology, 26.10.2020 15:30
Mathematics, 26.10.2020 15:30
Mathematics, 26.10.2020 15:30
Chemistry, 26.10.2020 15:30
English, 26.10.2020 15:40
Mathematics, 26.10.2020 15:40
English, 26.10.2020 15:40
Biology, 26.10.2020 15:40
Mathematics, 26.10.2020 15:40