subject
Engineering, 13.08.2021 18:50 hannahkharel2

Tech A says that the piston on a brake caliper that integrates the parking brake will need to be screwed back in on the threaded shaft to retract it into the bore. Tech B says that you need a special tool that mates to slots, grooves, or holes in the outer face of the caliper piston. Who is correct

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
question
Engineering, 04.07.2019 19:10
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
You know the right answer?
Tech A says that the piston on a brake caliper that integrates the parking brake will need to be scr...
Questions
question
English, 09.03.2020 11:04
question
History, 09.03.2020 11:04
Questions on the website: 13722363