Engineering, 27.07.2021 02:50 Amholloway13
An experiment on a surface-finishing operation of an overhead cam block auxiliary drive shaft was reported by Sirvanci and Durmaz (1993). The following is an adaption of the original experiment. The part had a target value of 75 um. The three experimental factors were type of insert (A), speed in rpm (B), and feed rate in millimeters per minute (C). A 23design was used; the (-, levels for the factors are (
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
An experiment on a surface-finishing operation of an overhead cam block auxiliary drive shaft was re...
Questions
Mathematics, 01.07.2020 15:01
Geography, 01.07.2020 15:01
English, 01.07.2020 15:01
Mathematics, 01.07.2020 15:01
Computers and Technology, 01.07.2020 15:01
