Engineering, 26.07.2021 14:50 kuadirkennedy
Calculate the force required in direct extrusion of 1100-O aluminum from a diameter of 6 mm. to 2 mm. Assume that the redundant work is 30% of the ideal work of deformation, and the friction work is 25% of the total work of deformation. K = 180 MPa and n = 0.20.
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Calculate the force required in direct extrusion of 1100-O aluminum from a diameter of 6 mm. to 2 mm...
Mathematics, 21.01.2022 23:00
English, 21.01.2022 23:00
Mathematics, 21.01.2022 23:00
Mathematics, 21.01.2022 23:00
Mathematics, 21.01.2022 23:00
English, 21.01.2022 23:00
Biology, 21.01.2022 23:00