Engineering, 14.07.2021 15:50 errinbaker4683

A spur pinion and gear pair is used to transmit a power of 25 kW. The teeth number of pinion is 18. The distance between the centers of the pinion and the gear is 144 mm. The sped ratio is 3, the
pressure angle is 20o and the face width is 50 mm. The rotational speed of pinion is 1200 rev/min. The
pinion and the gear material are through hardened Grade-2 with a hardness of 300 Brinell. The quality
standard number Qv is 7 and installation is open gearing quality. The power source and the driven
machine are subjected to medium and moderate shocks, respectively. Find the AGMA bending and
contact stresses and the corresponding factors of safety for a pinion life of 107 cycles and a reliability of
0.99.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Which of the following is the most important advantage of a large field of view? a. allows larger areas to be examined b. relieves eyestrain c. minimizes parallax errors. d. increases precision in proportion to the in- crease in field of view

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

You know the right answer?

A spur pinion and gear pair is used to transmit a power of 25 kW. The teeth number of pinion is 18....

Questions