Engineering, 23.06.2021 22:00 cassidyhead27

72.8% 13 11 40 / 42 IRON-CARBON SYSTEM Assignment: Refer to the Iron-Carbon Phase Diagram. Consider alloys containing 0.5% C, 0.83% C and 1% C, which have been slowly cooled from the austenite region (say 1100°C) to room temperature. Answer the following questions. 1. Why is slow cooling preferred to rapid cooling? 2. Describe the transformations that occur in the complete but slow cooling process of these alloys. 3. Calculate the relative amounts and compositions of the phases present at room temperature 4. Draw the microstructure, which would result in each case. This Assignment is Due in One Week's Time. D L e Type here to search

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 06.07.2019 04:10

Water flows at the rate of 200 i/s upwards through a tapered vertical pipe. the diameter at marks(3) clo5) the bottom is 240 mm and at the top 200 mm and the length is 5m. the pressure at the bottom is 8 bar, and the pressure at the topside is 7.3 bar. determine the head loss through the pipe. express it as a function of exit velocity head.

Answers: 3

Answer

You know the right answer?

72.8% 13 11 40 / 42 IRON-CARBON SYSTEM Assignment: Refer to the Iron-Carbon Phase Diagram. Consider...

Questions