Engineering, 10.06.2021 20:30 connorgking
A stepped shaft has the appearance shown in figure. The region AB is aluminum, having G 28 GPa, and the region BC is steel, having G 84 GPa. The aluminum portion is of solid circular cross section 45 mm in diameter, and the steel region is circular with 60-mm outside diameter and 30-mm inside diameter. Determine the maximum shearing stress in each material as well as the angle of twist at B where a torsional load of 4000 N. m is applied at B. Ends A and C are rigidly clamped.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
A stepped shaft has the appearance shown in figure. The region AB is aluminum, having G 28 GPa, an...
Questions
Computers and Technology, 06.07.2019 02:20
Computers and Technology, 06.07.2019 02:20
Computers and Technology, 06.07.2019 02:20
Social Studies, 06.07.2019 02:20
Mathematics, 06.07.2019 02:20
