subject
Engineering, 03.06.2021 01:20 makwoods417ow2txa

7. (15) An accelerometer has a mass of 1.5 g and silicon sensor parts. The four flexural members are 110 microns long and their cross section is a square, with 4 microns by 4 microns. Silicon has a modulus of elasticity of 150 GPa. (a) Find the relation between the acceleration and the strain measured by any of the piezoresistive sensors on the vertical flexural members. (b) Calculate the strain at an acceleration of 2.1g if the strain gauges are small and placed 0.03 mm from the center of the flexural member. (State your assumptions. If you are missing any information to solve the problem, leave those as variables, if applicable)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
7. (15) An accelerometer has a mass of 1.5 g and silicon sensor parts. The four flexural members are...
Questions
question
Mathematics, 08.11.2019 06:31
Questions on the website: 13722363