Engineering, 01.06.2021 02:00 gursparks

Two objects labeled K and L have equal mass but densities 0.95Do and Do, respectively. Each of these objects floats after being thrown into a deep swimming pool. Which is true about the buoyant forces acting on these objects? a. The buoyant force is greater on Object K since it has lower density and lower density objects always float "higher" in the fluid.
b. The buoyant force is greater on Object L since it is denser than K and therefore "heavier."
c. The buoyant forces are equal on the objects since they have equal mass.
d. Without knowing the specific gravity of the objects, nothing can be determined.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Derive the 2-d finite difference equation for a uniform grid for a node: a) at a plane surface with a uniform heat flux b) at an internal corner with convection

Answers: 1

Answer

Engineering, 06.07.2019 05:10

Apipe of diameter 200 mm (constant) carrying water with an 5 mis and total head is density 1000 kg/m ) with velocity tpward slope. at a certain point, where the elevation is 5 m above a datum,the 21.5 m. a) determine the pressure of the pipe at 5m elevation. determine the pressure at elevation 10m (above same datum) if the of total head at 5m elevation.

Answers: 1

Answer

You know the right answer?

Two objects labeled K and L have equal mass but densities 0.95Do and Do, respectively. Each of these...

Questions