Engineering, 28.05.2021 19:10 elijiahman99
A cold-rolled sheet metal that is 40 mm wide and has a thickness of 5.00 mm is going to be bent into a V shape with a 60° angle. The die opening dimension is 50 mm. Each of the two straight sides of the bent part will be 50 mm long. The bend has a radius of 10 mm. The steel tensile strength is assumed as 400 MPa.
Determine:
a. The required blank size to provide the final workpiece dimensions
b. The force required to bend the part
Answers: 2
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
A cold-rolled sheet metal that is 40 mm wide and has a thickness of 5.00 mm is going to be bent into...
History, 20.09.2019 06:30
Chemistry, 20.09.2019 06:30
Computers and Technology, 20.09.2019 06:30
World Languages, 20.09.2019 06:30
Social Studies, 20.09.2019 06:30
Biology, 20.09.2019 06:30
Mathematics, 20.09.2019 06:30
Social Studies, 20.09.2019 06:30
History, 20.09.2019 06:30
Mathematics, 20.09.2019 06:30
Chemistry, 20.09.2019 06:40