Engineering, 28.05.2021 14:30 deb69

Below, atomic radius, crystal structure, electronegativity, and the most common valence are tabulated, for several elements; for those that are nonmetals, only atomic radii are indicated. Element Atomic Radius Crystal Structure Electronegativity Valence (nm)
Cu 0.1278 FCC 1.9 +2
C 0.071
H 0.046
O 0.060
Ag 0.1445 FCC 1.9 +1
Al 0.1431 FCC 1.5 +3
Co 0.1253 HCP 1.8 +2
Cr 0.1249 HCP 1.6 +3
Fe 0.1241 HCP 1.8 +2
Ni 0.1246 FCC 1.8 +2
Pd 0.1376 FCC 2.2 +2
Pt 0.1387 FCC 2.2 +2
Zn 0.1332 HCP 1.6 +2
Which of these elements would you expect to form the following with Zinc:
(a) A substitutional solid solution having complete solubility
(b) A substitutional solid solution of incomplete solubility
(c) An interstitial solid solution

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

Below, atomic radius, crystal structure, electronegativity, and the most common valence are tabulate...

Questions