Engineering, 27.05.2021 19:50 gilliandooley1002
Which of the following statements is true about cutting speed for reaming operations on the lathe?
POSSIBLE ANSWERS:
Cutting speed for reaming is higher than other holemaking operations.
Smaller diameter reamers require lower cutting speeds.
Operators should decrease cutting speed with greater depth.
Cutting speed for reaming is about half of that for drilling.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
Which of the following statements is true about cutting speed for reaming operations on the lathe?...
Questions
Chemistry, 18.01.2020 02:31
Mathematics, 18.01.2020 02:31
Biology, 18.01.2020 02:31
Mathematics, 18.01.2020 03:31
Mathematics, 18.01.2020 03:31
Mathematics, 18.01.2020 03:31
Mathematics, 18.01.2020 03:31
