Engineering, 19.05.2021 22:50 lulu5351

Question #8 Multiple Select
Salwa is a researcher at the University of California, Berkley. She wants to develop an irrigation system for crops that could also provide
hydroelectric power for farms to produce their own energy in an entirely sustainable way. She has a like-minded team of researchers to
help her develop her project, but she needs research funding. To focus her funding efforts, she wants to select no more than three
potential sources that would be best positioned to meet her needs. Where should she turn for project funding? (Select all that apply.)
National Science Foundation (NSF) funding
university funding
state funding
private sector funding

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

Engineering, 06.07.2019 03:20

1kg of water contained in a piston-cylinder assembly undergoes two processes in series from an initial state where the pressure is 3.0 bar and the temperature is 150°c process 1-2: the water is compressed isothermally to a volume of 0.25 m^3 with 120 kj of work being done to the system. process 2-3: the water is heated at constant volume to a final pressure of 10 bar. a. find the change in internal energy for the system. b. calculate the amount of heat transferred, in kj. c. sketch both processes on a t-v diagram. (196.33 kj/kg, 76.33 kj)

Answers: 1

Answer

Engineering, 06.07.2019 04:20

Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above

Answers: 3

Answer

You know the right answer?

Question #8 Multiple Select
Salwa is a researcher at the University of California, Berkley. S...

Questions