Engineering, 18.05.2021 01:00 madimocaj

Please help and show all work. I am extremely behind on this. Thanks 1. A worker on a zip line crew lifts participants weighing approximately 200 lb several times a day from the ground 20 feet below. A block and tackle system is designed with 50 lb of effort force designed to lift the materials.
--a. What is the required actual mechanical advantage?
--b. How many supporting strands will be needed in the pulley system?

2. A simple gear train is composed of three gears. Gear A is the driver and has 10 teeth, gear B has 8 teeth, and gear C has 20 teeth.
--a. If the output is at C, what is the gear ratio?
--b. If gear A rotates at 60 rpm, how fast is gear C rotating?
--c. If the output of torque at gear C is 150 ftlb, what is the input torque at gear A?

3. Look at the picture provided.
--a. What class of lever is shown in the figure? (How do you know?)
--b. How much effort force is needed to balance the 100 lb load?

Please help and show all work. I am extremely behind on this. Thanks

1. A worker on a zip line cr

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

You know the right answer?

Please help and show all work. I am extremely behind on this. Thanks 1. A worker on a zip line crew...

Questions