Engineering, 14.05.2021 18:20 shaheedbrown06

6. If Mrs. Campbell is pulling on her dog Harper's collar with a force of 50 N at the angle shown, what is the Fy (upward force) on Harper's collarineck? Fy=_N
(report to x. x decimal places and include a + or - sign)
SON
38 deg
7. The seat of a swing exerts an 85 lbf force on the swings chain, pulling down and
to the right, at a 40° angle as shown. What is the magnitude of the x and y force
components? (report to x. x decimal places and include a + or - sign)
L.
40
85 lbf
Fx =
Ibf
Fy =
_lof
8. In the figure shown, determine the net moment about point O if the force is 20
Newtons. Include the +/- sign in your answer.
Newton'meters
(report to x. x decimal places and include a + or - sign)

6. If Mrs. Campbell is pulling on her dog Harper's collar with a force of 50 N at the

angle shown

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

6. If Mrs. Campbell is pulling on her dog Harper's collar with a force of 50 N at the angle shown,...

Questions