subject
Engineering, 13.05.2021 21:40 Kategaldamez3

Based on the following passage, what was the intended effect of building cities in concentric circles? The first major urban planning trend of the 20th century was Ebenezer Howard's Garden City movement, outlined in his 1902 book
Garden Cities of To-Morrow, in which he envisioned cities designed as a series of concentric circles, with development flanking five
wide, circular roads, each separated by greenbelts. Each circular community could house around 32,000 people and would be connected
to a larger, circular central city and neighboring communities by rail and highways.
O to allow cities to fit in oddly shaped geographic zones
O to allow residents to live in "green" areas away from heavy industry
O to discourage the expensive and time consuming practice of zoning
to isolate the residents of each zone

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Based on the following passage, what was the intended effect of building cities in concentric circle...
Questions
question
Mathematics, 30.11.2020 21:30
Questions on the website: 13722367