Engineering, 06.05.2021 14:00 chmereaustin1

Write a program that models 2 vehicles (Car and Truck) and will be able to simulate driving and refueling them in the summer. Car and truck both have fuel quantity, fuel consumption in liters per km and can be driven given
distance and refueled with given liters. But in the summer both vehicles use air conditioner and their fuel
consumption per km is increased by 0.9 liters for the car and with 1.6 liters for the truck. Also the truck has a tiny
hole in his tank and when it gets refueled it gets only 95% of given fuel. The car has no problems when refueling and
adds all given fuel to its tank. If vehicle cannot travel given distance its fuel does not change

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

Write a program that models 2 vehicles (Car and Truck) and will be able to simulate driving and refu...

Questions