Engineering, 06.05.2021 04:50 gregorio03
You wish to design a cantilever beam with a square cross section and length L that can support an end load of F without yielding. You also wish to minimize the amount the beam deflects under load. What is the free variable(s) (other than the material) for this design problem?
a. End load, F.
b. Length, L.
c. Beam thickness, b
d. Deflection, δ
e. Answers b and c.
f. All of the above.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
You wish to design a cantilever beam with a square cross section and length L that can support an en...
Questions
Advanced Placement (AP), 19.05.2020 16:18
Biology, 19.05.2020 16:18
Mathematics, 19.05.2020 16:18
Mathematics, 19.05.2020 16:18
Chemistry, 19.05.2020 16:18
Chemistry, 19.05.2020 16:18
Biology, 19.05.2020 16:19
