Engineering, 19.04.2021 18:20 esekvng1596

How do competition and the introduction of novel businesses Impact the transportation Industry? (Select all that apply.) Novel services might lack the security, accountability, and oversight of traditional services, especially those that are regulated;
therefore, they might seek out either deregulation or inclusion.
Traditional services may need to find new ways to operate that minimize overhead in order to compete.
Traditional services might feel economic pressure to offer innovative features that new businesses bring to market.
Lack of competition and fewer innovative new businesses means that governments will need to financially stimulate the entire
industry.
Ku

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

How do competition and the introduction of novel businesses Impact the transportation Industry? (Sel...

Questions