Engineering, 18.04.2021 06:00 robert7248

Choose a jet aircraft to use as your example for this activity. It should not be an exotic jet aircraft, as you will need to find data online for the aircraft. If you choose a military aircraft, make sure you are not using classified data to support your work. Only use data that is available to all on the internet. You will then use the data you gathered for this particular aircraft to show examples of your performance problems and how you derived them. To provide an outlook to some of the aspects of next module's unaccelerated performance, select a jet aircraft of your choice, choose three (3) of the following items of performance, and prepare an instructional presentation (utilizing a presentation tool of your choice - see resources in the Online Tools section) that explains in-depth how to find these different items of performance for a jet aircraft. This will be a standalone presentation and will not be attached to your comprehensive presentation project. Available choices:

maximum forward speed in level flight
absolute ceiling
best angle of climb airspeed
angle of climb
best rate of climb airspeed
rate of climb
maximum endurance airspeed
maximum range airspeed
influence of weight on performance
influence of altitude on performance
influence of configuration on performance

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Ashielded metal arc-welding operation is accomplished in a work cell by a fitter and a welder. the fitter takes 5.5 min to load components into the welding fixture at the beginning of the work cycle, and 1.5 min to unload the completed weldment at the end of the cycle. the total ength of the weld seams 1200 mm, and the travel speed used by the welder averages 300 mm/min. every 600 mm of seam length, the welding stick must be changed, which takes 0.8 min. while the fitter is working, the welder is idle (resting): and while the welder is working the fitter is idle. (a) determine the average arc-on time as a fraction of the work cycle time. (b) how much improvement in arc-on time would result if the welder used flux-cored arc welding (manually operated), given that the spool of weld wire must be changed every 10 weldments, and it takes the welder 5.0 min to accomplish the change? (c) what are the production rates for these two cases (weldments completed per hour)? attach your work and solutions.

Answers: 1

Answer

You know the right answer?

Choose a jet aircraft to use as your example for this activity. It should not be an exotic jet aircr...

Questions