subject
Engineering, 15.04.2021 20:50 hernan99961

Consider the signal v(t) below. Waveform for Question 6 What is the corresponding trigonometric Fourier series of v(t)? Answer Format: a subscript 0 space equals bold italic P a subscript n space equals space fraction numerator open parentheses bold italic B (negative 1 )to the power of n space plus space bold italic C close parentheses over denominator open parentheses n straight pi close parentheses to the power of bold italic D end fraction b subscript n equals fraction numerator negative bold italic X over denominator open parentheses n straight pi close parentheses to the power of bold italic Y end fraction

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
question
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
question
Engineering, 04.07.2019 19:20
A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.
Answers: 2
You know the right answer?
Consider the signal v(t) below. Waveform for Question 6 What is the corresponding trigonometric Four...
Questions
question
English, 08.04.2021 20:20
question
Mathematics, 08.04.2021 20:20
question
Geography, 08.04.2021 20:20
question
Spanish, 08.04.2021 20:20
question
Spanish, 08.04.2021 20:20
question
Business, 08.04.2021 20:20
Questions on the website: 13722363