Engineering, 15.04.2021 15:30 alexanderavrett

Design an automotive suspension such that the vertical acceleration felt by the driver is less than 2g for all speeds between 40 and 80 mph. Assume the road surface has an amplitude of 0.5 feet and wavelength equal to 3.14 ft. Model the vehicle as a single degree of freedom (base excitation) system with a vehicle/driver weight of 1500 lb and a damping ratio of 0.05. Use a Matlab script to: Select a stiffness value that meeting the acceleration requirement. Calculate the displacement transmissibility for all speeds between 40 and 80 mph. Use the displacement transmissibility to find the acceleration for all speeds. Plot the magnitude of the acceleration that the driver feels for all speeds between 40 and 80 mph.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

You know the right answer?

Design an automotive suspension such that the vertical acceleration felt by the driver is less than...

Questions