Engineering, 13.04.2021 01:00 juliopejfuhrf7541
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely reversing transverse load at the other end of ±1.3 kN. The material is AISI 1080 hot-rolled steel. If the rod must support this load for 3 × 104 cycles with a design factor of 1.5, what dimension should the square cross section have? Neglect any stress concentrations at the support end.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely rever...
Questions
Business, 28.05.2021 06:20
Spanish, 28.05.2021 06:20
Spanish, 28.05.2021 06:20
Mathematics, 28.05.2021 06:20
English, 28.05.2021 06:20
English, 28.05.2021 06:20
Mathematics, 28.05.2021 06:20
Mathematics, 28.05.2021 06:20
