Engineering, 09.04.2021 02:20 genyjoannerubiera

A pipeline is proposed to carry 90 deg F water to the top of a spray cooling pond. Flow through the smooth pipe which has an outside diameter of 36 in and a wall thickness of 3/8 in, is to be 26,000 gpm. The friction factor for the pipe is 0.01. For the proposed system the pressure at the pump inlet is 20 psig, and the equivalent length of the pipe from the pump outlet to the pipe exit is 2425 ft. The pond is 160 ft above the pump. For the conditions given, the operating head of the pump (ft) is most nearly:

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

A pipeline is proposed to carry 90 deg F water to the top of a spray cooling pond. Flow through the...

Questions