subject
Engineering, 07.04.2021 20:40 ooferson

Problem 1 On a 20°C sunny day with no wind speed, and an air density of 1.2 kg/m², a 1500 kg vehicle travels
along an asphalt roadway with a 6° grade at 100 km/h and a rolling resistance coefficient of 0.013.
The vehicle center of gravity is located 0.6 m from the ground in the center of the 2.5 m wheelbase
with 0.66 m wheels and has a frontal area of 2.05 m² and a drag coefficient of 0.32.
Calculate the aerodynamic, grading, and rolling resistance.
Problem 2
After some engine and transmission performance upgrades, the same vehicle is taken to a test track
to find out the new vehicle top speed. The upgrades have increased engine torque to 450 Nm and
engine horsepower to 300 kW and an overall powertrain efficiency of 88%. After the upgrades, the
minimum gear ratio of the transmission is 0.9, and the differential gear ratio is 3.21.
Calculate the maximum speed of the vehicle
Problem 3
The same vehicle travels along a level asphalt roadway at 100 km/h, with a coefficient of road adhe-
sion of 0.72, and encounters a large obstacle 50 m ahead and needs to stop to avoid striking the
obstacle.
Calculate the braking force at the front and rear wheels that is required to stop just before the
obstacle.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
question
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
You know the right answer?
Problem 1 On a 20°C sunny day with no wind speed, and an air density of 1.2 kg/m², a 1500 kg vehicl...
Questions
question
Mathematics, 06.11.2020 05:30
question
Mathematics, 06.11.2020 05:30
question
Mathematics, 06.11.2020 05:30
question
Mathematics, 06.11.2020 05:30
question
Mathematics, 06.11.2020 05:30
question
Mathematics, 06.11.2020 05:30
Questions on the website: 13722360