subject
Engineering, 06.04.2021 04:40 sporting06

Tungsten is being used at half its melting point (Tm≈3,400◦C) and astress level of 160 MPa. An engineer suggests increasing the grain size by afactor of 4 as an effective means of reducing the creep rate.(a)Do you agree with the engineer? Why? What if the stress level were equalto 1.6 MPa?(b)What is the predicted increase in length of the specimen after 10,000hours if the initial length is 10 cm?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 19:10
Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m
Answers: 1
question
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
question
Engineering, 06.07.2019 03:20
Explain in your own word the concept of a solid solution, in alloys, and how it can be created.
Answers: 3
You know the right answer?
Tungsten is being used at half its melting point (Tm≈3,400◦C) and astress level of 160 MPa. An engin...
Questions
question
Mathematics, 26.04.2021 23:30
Questions on the website: 13722363