Engineering, 06.04.2021 03:30 farhan61
Below is a topology for a typical variation of the Colpitts oscillator. Assume you want this oscillator to run at a center frequency of 7.5 MHz where C1 can be used for fine tuning. You have available the following standard +/- 10% tolerance capacitor values that you could use for C3 and C4. Which value should you pick?
a. 270 pF
b. 330 pF
c. 390 pF
d. 470 pf
e. 560 pf
f. 680 pf
g. 820 pF
h. 910 pF
i. 1000 pF
j. 1200 pF
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
You know the right answer?
Below is a topology for a typical variation of the Colpitts oscillator. Assume you want this oscilla...
Questions
History, 19.09.2019 20:20
Mathematics, 19.09.2019 20:20
Mathematics, 19.09.2019 20:20
History, 19.09.2019 20:30
Mathematics, 19.09.2019 20:30
