Engineering, 06.04.2021 03:20 dacas7300

A hand dryer blows heated air downwards out of the exit duct at a velocity of 4 m/s. The temperature and density of the ambient air at the inlet are 15 C and 1.23 kg/m3, while at the outlet it has temperature 35 C and density 1.15 kg/m The blower power is 10.0 W, and the heater power is 715 W. Consider the inlet to be at the large mass of ambient air which has negligible velocity. a) What is the pressure at the outlet? 0.5 m/s, 35 °C
b) You will be applying the energy equation. Why can you ignore any height differences in this situation?
c) If the specific heat of air C-1000 J/(kg K), where Δ11 unit mass from the inlet to outlet. CAT, find the change in internal energy per
d) Find the mass flow rate through the dryer
e) What is the power loss in the system?
f) What is the loss in the system?
g) What is the head loss in the system?
h) What is the total loss coefficient of the system, referred to the outlet velocity? the inlet? Explain why.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

You know the right answer?

A hand dryer blows heated air downwards out of the exit duct at a velocity of 4 m/s. The temperature...

Questions