Engineering, 03.04.2021 03:20 frankieflores02

A jet aircraft is in level flight at an altitude of 30,000 ft with an airspeed of 500 ft/s. The aircraft has a gross weight of 19,815 lb, a wingspan of 53.3 ft, and an average chord length of 6 ft. The Oswald efficiency factor is 0.81 and the zero-lift drag coefficient is equal to 0.02. The jet has two turbofan engines, each producing a maximum thrust of 3,650 lb at sea level. Required:
a. Create a plot of the drag polar for this aircraft for CL from 0 to 5. Plot CL on the vertical axis, CD on the horizontal axis, and do not include negative CL values.
b. What is the total drag coefficient at the flight condition described above?
c. What is the required thrust for level flight at this altitude in lb?
d. If the pilot runs the engines at maximum thrust, what is the instantaneous rate of climb at this altitude and velocity?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

You know the right answer?

A jet aircraft is in level flight at an altitude of 30,000 ft with an airspeed of 500 ft/s. The airc...

Questions