Engineering, 31.03.2021 03:20 dria40

This problem will take you through the steps needed to calculate the appropriate mass of Tris base, EDTA, and salt (NaCl in this example), and volume of 1 N HCL to use in the preparation of your Tris buffer stck solution for the enzyme kinetics unit. The final volume, concentrations and pH values have been randomized, and are not necessarily the values you have been assigned to use in your stock solution. The formula weight for Tris is 121.1 g/mole, EDTA is 372.2 g/mole, and NaCl is 58.44 g/mole.
Tris base is uncharged (conjugate base), and Tris-HCl has a charge of +1 (conjugate acid).
The pKa' for Tris is 8.2 (use this value in the initial calculation of the Henderson-Hasselbalch equation to determine the CB/CA ratio).
When you solve the final Henderson-Hasselbalch equation to calculate more precisely the amount of HCl to add, use the pKa (8.08) plus your calculated ΔΔpKa.
Provide three significant figures and include units, when appropriate, in your answers
You wish to make 85.0 mL of 158 mM Tris buffer pH 8.20, containing 25.5 mM EDTA and 43.5 mM NaCl.
What mass of Tris base would you need to weigh out?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

This problem will take you through the steps needed to calculate the appropriate mass of Tris base,...

Questions