Engineering, 30.03.2021 17:50 Daddysgirl2019

Create an essay that contains at least 500 words. Evaluate at least two different school Web sites. Estimate the number of images you would like to include and how many people will be needed to create the site. Interview one Web site designer to get information. Your implementation plan will have three sections: project team, budget, and process to build the Web site. Assignment Guidelines
Using information from research, your essay should contain the following:

Review two school Web sites for elements, visuals, and design.
Interview a Web site developer to gain information about cost for a Web site like one of the school examples.
Briefly describe the staff and job tasks of people on your proposed Web site team
Provide information about the site’s functionality and the best ways to use it.
List references for any research.
Write an essay that summarizes your findings about an implementation plan for your school.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

You know the right answer?

Create an essay that contains at least 500 words. Evaluate at least two different school Web sites....

Questions