Engineering, 25.03.2021 20:10 leapfroggiez

To design a dc bias circuit, some reasonable approximations may be used. The first assumption is the voltage from emitter to ground. VE is typically one-fifth to one-tenth of the

supply voltage, VCC. Selecting the emitter voltage in this way will permit calculating the

emitter resistance, RE and then the collector resistance, RC by using the following equations:

VE ≈ 1 / 10 VCC

RE ≈ VE / IC

RC = (VCC - VCE - VE) / IC

Hence, the base voltage is approximately equal to the emitter voltage,

or more exactly, VB = VE + VBE.

Finally, determine the values for the base resistors, RB1 and RB2 by approximating

RB2 ≤ 1/ 10 ( βRE )

RB1 can be obtained by using the following equation,

VB = RB2

/ (RB2 + RB1 ) ( VCC )

Now, by referring to the proposed circuit as shown in Figure 1, select appropriate values for

RB1

, RB2

, RC and RE. Simulate the circuit and print the output waveform, Vo for a sinusoidal

input signal of 10mV at frequency 1kHz.

To design a dc bias circuit, some reasonable approximations may be used. The first

assumption is

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Asimply supported beam abc of length l has ab of length hl and second moment of area / and bc of length hl and second moment of area i2. determine the strain energy stored in the beam when it is subject to a vertical load f at its midpoint and the consequential central deflection.

Answers: 2

Answer

You know the right answer?

To design a dc bias circuit, some reasonable approximations may be used. The first assumption is th...

Questions