Engineering, 22.03.2021 17:30 hbked23
A shaft is made from a tube, the ratio of the inside diameter to the outside diameter is 0.6. The material must not experience a shear stress greater than 500KPa. The shaft must transmit 1.5MW of mechanical power at 1500 revolution per minute. Calculate the shaft diameter
Answers: 2
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
A shaft is made from a tube, the ratio of the inside diameter to the outside diameter is 0.6. The ma...
Mathematics, 12.11.2020 22:10
Health, 12.11.2020 22:10
Social Studies, 12.11.2020 22:10
History, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10
Mathematics, 12.11.2020 22:10