Engineering, 21.03.2021 09:40 fbr45508

Question#01 a) Write a comprehensive note on cooling load calculation, elaborating the following.

1- Room sensible heat, effective room sensible heat and total sensible heat.

2- Room latent heat, effective room latent heat and total latent heat.

3- Grand total heat

b) Write a comprehensive note describing the selection of a suitable system (VRV/VRF system, Package system or Chilled Water System) for the following.

1- Office building with a total cooling load of 50 tons.

2 -A three story existing residential building consisting of various spaces with a total cooling load of 150 tons.

3- A seven story hospital building with a total cooling load of 1500 tons.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

Question#01 a) Write a comprehensive note on cooling load calculation, elaborating the following.

Questions

SAT, 09.10.2021 01:00

Designates how work units are going to optimize resources...

Engineering, 09.10.2021 01:00