subject
Engineering, 19.03.2021 02:10 Flameking1223

Consider water at 27C in parallel flow over an isothermal, 1-m-long flat plate with a velocity of 2 m/s. (a) Plot the variation of the local heat transfer coefficient, hx(x), with distance along the plate for three hL, N/hL,1 LN L/N, hL flow conditions corresponding to transition Reynolds numbers of (i) 5 105 , (ii) 3 105 , and (iii) 0 (the flow is fully turbulent). (b) Plot the variation of the average heat transfer coefficient with distance for the three flow conditions of part (a). (c) What are the average heat transfer coefficients for the entire plate for the three flow conditions of part (a)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
You know the right answer?
Consider water at 27C in parallel flow over an isothermal, 1-m-long flat plate with a velocity of 2...
Questions
question
Mathematics, 03.07.2019 06:30
Questions on the website: 13722363