Engineering, 18.03.2021 01:20 valles36

1. The organic carbon adsorption data given below were obtained using two activated carbon samples, A and B. In each case 1.0 g of carbon and a liquid volume of 1.0 L were used. Determine the appropriate model to be used in each case. Initial Concentration Equilibrium Concentration, g/m3
g/m3 A B
1.0 0.010 0.053
2.0 0.020 0.124
4.0 0.040 0.290
8.0 0.081 0.677
16.0 0.165 1.58
32.0 0.344 3.67
64.0 0.751 8.52
128.0 1.843 19.66
2. A secondary wastewater effluent having a total organic carbon (TOC) concentration of 12 g/m3 is to be treated further by activated carbon adsorption. The objective is produce water having no more than 1.0 g/m3 TOC. Determine the amount of a carbon that would be necessary per cubic meter of secondary effluent if the carbon characteristics were those of (a) carbon A in Part 1 and (b) carbon B in Part 1. Assume the system is a batch process.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

You know the right answer?

1. The organic carbon adsorption data given below were obtained using two activated carbon samples,...

Questions