Engineering, 12.03.2021 15:00 valoiserika1229
1. Tool life tests on a lathe have resulted in the following data: (1) at a cutting speed of 375 ft/min, the tool life was 5 min; (2) at a cutting speed of 275 ft/min, the tool life was 50 min. (a) Determine the parameters n and C in the Taylor tool life equation. (b) Based on the n and C values, what is the likely tool material used in this operation
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
You know the right answer?
1. Tool life tests on a lathe have resulted in the following data: (1) at a cutting speed of 375 ft/...
Questions
Mathematics, 14.05.2021 21:00
History, 14.05.2021 21:00
Biology, 14.05.2021 21:00
Arts, 14.05.2021 21:10
Mathematics, 14.05.2021 21:10
Mathematics, 14.05.2021 21:10
English, 14.05.2021 21:10
Mathematics, 14.05.2021 21:10
