Engineering, 08.03.2021 23:30 womankrush538

A wide flange steel beam shown in the figure below supports a permanent concrete masonry wall, floor slab, architectural finishes, mechanical and electrical systems. Determine the uniform dead load in
KN per linear meter acting on the beam. The wall is 2.8 m high, non-load bearing and laterally braced at
the top to upper floor framing (not shown). The wall consists of 250 mm. lightweight reinforced concrete
masonry units with an average weight of 4.31 KN/m2
. The composite concrete floor slab construction spans
over simply supported steel beams, with a tributary width of 3 m, and weighs 2.4 KN/m2
. The estimated
uniform dead load for structural steel framing, fireproofing, architectural features, floor finish, and ceiling
tiles equals 1.15 KN/m2
, and for mechanical ducting, piping, and electrical systems equals 0.29 KN/m2
.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

You know the right answer?

A wide flange steel beam shown in the figure below supports a permanent concrete masonry wall, floo...

Questions