Engineering, 08.03.2021 20:20 Answers4833
A punch for making holes in steel plates is shown in Fig. a. below. Assume that a punch having diameter d = 20 mm is used to punch a hole in an 8 mm plate, as shown in the cross-sectional view (Fig. b). If a force P = 110 kN is required to create the hole, what is the average shear stress in the plate and the average compressive stress in the punch?
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
You know the right answer?
A punch for making holes in steel plates is shown in Fig. a. below. Assume that a punch having diame...
Questions
Social Studies, 29.01.2020 22:43
Geography, 29.01.2020 22:43
Biology, 29.01.2020 22:43
English, 29.01.2020 22:43
English, 29.01.2020 22:43
Mathematics, 29.01.2020 22:43
Biology, 29.01.2020 22:43
Arts, 29.01.2020 22:43
English, 29.01.2020 22:43
Biology, 29.01.2020 22:43
History, 29.01.2020 22:43
Social Studies, 29.01.2020 22:43
