Engineering, 04.03.2021 15:10 9826zed

An engine working Otto cycle has aA compression ratio 8.2 to 1 beginning of the compression stroke .The condition inside the cydnders are Pressure = 93KN/m^3 abs, Temperature 13°C. The Maximum pressure in the cylinder is 320KN/m^3 abs .If gamma for the working substance is 1.4, Determining the pressure and temperature at which of the following points in the cycle:
1. End of compression stroke
2. Beginning of the compression stroke
3. End of expansion stroke

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

An engine working Otto cycle has aA compression ratio 8.2 to 1 beginning of the compression stroke...

Questions