Engineering, 01.03.2021 20:50 25linm
You are moving 300 CCY per hour of material from the cut to the fill along a haul road that is 6,000 lf long. The dry unit weight of the material is 2,500 lb/CCY with a 12% water content. The elevation of the cut is 500 feet above sea level. The project manager anticipates the completion of the embankment, which is at an elevation of 900 feet, can be completed in 65 hours using a spread of 4 scrapers, 2 dozers, 1 compactor, and a water truck. What is the grade resistance as a percent when hauling from the cut to the fill
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
You are moving 300 CCY per hour of material from the cut to the fill along a haul road that is 6,000...
Questions
History, 18.12.2020 02:30
English, 18.12.2020 02:30
Mathematics, 18.12.2020 02:30
Mathematics, 18.12.2020 02:30
Mathematics, 18.12.2020 02:30
Mathematics, 18.12.2020 02:30
Mathematics, 18.12.2020 02:30
