subject
Engineering, 28.02.2021 16:20 573589

Close to 16 billion pounds of ethylene glycol (EG) were produced in 2013. It previously ranked as the twenty-sixth most produced chemical in the nation on a total pound basis. About one-half of the EG is used for antifreeze, while the other half is used in the manufacture of polyesters. In the polyester category, 88% was used for fibers and 12% for the manufacture of bottles and films. The 2013 selling price for EG was $0.60 per pound. It is desired to produce 200 million pounds per year of EG. The reactors are to be operated isothermally. A 16.1 mol/dm3 solution of ethylene oxide (EO) in water is mixed with an equal volumetric solution of water containing 0.9 wt% of the catalyst H2SO4 and fed to two 800-gal CSTRs in series at 7.24 dm3 /s. The specific reaction rate constant is 0.311 min-1 . Because water is present in such excess, the concentration of water at any time is virtually the same as its initial concentration, and the rate law is independent of the concentration of H2O. The reaction is first order in EO: Catalyst
EO+ W â EG

a. What is the conversion exiting the first reactor?
b. What is the conversion exiting the second reactor?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
You know the right answer?
Close to 16 billion pounds of ethylene glycol (EG) were produced in 2013. It previously ranked as th...
Questions
question
Biology, 04.01.2020 19:31
Questions on the website: 13722361