Engineering, 28.02.2021 16:40 Prettygirlyaya

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in terms of the following parameters: Effective laser spot size, the cured line width on the surface (Lw) and scan speed (V); liquid resin layer thickness (Zr) and cure (volume) shrinkage (S); and the time per layer to configure the liquid, wiper time (tw). Assume neighboring tracks are just touching (not overlapping). Apply this model to the following problems: a. For Zr = Lw = 0.1 mm, Vs = 2000 mm/s, and S = 15 vol %, what is the volume build rate per hour, neglecting the wiper time.
b. From (a), calculate the time to build a single 10 x 10 cm layer and a 10-cm cube (= 1 L).
c. For what wiper cycle time, does the wiper time add 10% to the total time in this case.
d. For what (smaller) layer area does the wiper time double the total time.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler

Answers: 2

Answer

You know the right answer?

Derive a basic analytical model for the volume build rate of a direct, single-laser SL process in te...

Questions